Model: BIOS Tempest i5400XT (S5396)
Operating System: Not Applicable (Note: might work with other versions of this os.)
File: S5396_v101.zip
Comments:
Socket 771
Intel 5400 Chipset
Fixed an issue where if you used a Harpertown 2.50GHz CPU you were unable to resume from a S3 wait state
Added Hotkey F11 pressed will pop up a BIOS boot menu so that chose boot device
Fixed an issue where an nVidia Quadro Plex IV would show a next to one set of cards in the device manager
Updated CPU Micro Code
Added Hotkey F12 pressed forces LAN PXE boot
Fixed an issue where disabling PATA or setting SATA to compatible when there is a SATA drive plugged to Port 1 or Port 3 BIOS will show error message 0200: Failure Fixed Disk 1 on POST screen
Set BIOS continuous reboot mode by item
Updated ESB2 LAN PXE Option ROM is set to [Enable] by default
Fixed an issue where DIMM size was displayed wrong in the DMI table
Set max L2 cache size to 12288KB
Fixed an issue where PCI-X slot 2 and 3 Option ROM disable function wouldn’t disable properly
Fixed an issue where if you would disable the WOL function from BIOS setup it wouldn’t also apply to a PCI32 LAN card
Updated to Intel MRC to v1.1
Updated ESB2 AHCI Option ROM to v1.12E
Adjusted thermal control and set auto fan control enabled as default
Fixed and issue where dual VGA cards would show a yellow next to the 2nd card under Vista
Fixed an issue where the auto fan controls were not working properly
Fixed an issue where the Front and Rear FAN controls were not working properly
Fixed an issue where auto fan control would not works after S3 resume
Updated the Intel MRC code
Fixed an issue where S3 would fail if using RAID
Fixed an issue where IDE and USB CD-ROM would not function properly
Fixed an issue where booting from RAID with SATA CD-ROM would cause the system to hang during POST (d2H)
BIOS Firmware File