Model: BIOS Tempest i5100X (S5375-1U)
Operating System: Not Applicable (Note: might work with other versions of this os.)
File: S5375-1U_v304.zip
Comments:
Socket 771
Intel 5100 Chipset
Fixed a LAN low performance issue
Fixed an issue where PECI Hardware Monitoring method was not functioning correctly
Fixed an issue where the CPUs EIST function would not work properly
Fixed an issue where Chassis Intrusion Detection was not working properly
Fixed an issue where any FAN speed less than 800 RPM will be reported as a FAN failure during POST
Updated CPU Micro Code
Fixed an issue where if you had 4GB of memory installed with a PCI-E VGA card and Windows XP 32-bit
plus SP2, only 2GB system memory would show as available during POST
Fixed an issue where an Audio device would show a ! in the device manager
Updated PECI Support
Updated the High Precision Event Timer support
Updated support for Realtek ALC262 Rev C2 Audio chip
Updated support for the Intel 82573 LAN chip
Updated embedded VGA Option ROM to v1.09.03
Added bios ability to reverse PCI scan order
Added bios support to [Enable/Disable] onboard LAN Option ROM
Fixed a CentOS error attaching device data in dmesg error message
Fixed a CentOS 5.1 shut down issue
Fixed a Redirection After Bios POST Boot Loader issue
Updated Console Redirect function to allow the system to always boot to bio by pressing F1, F7 or F11Â
 from the remote side
Added support for SATA RAID arrays over 2TB in size
Updated DMI information
Fixed an issue where RedHat 5.1 64-bit would hang during POST (02) if rebooting from the OS
Set USB 2.0 Controller Mode default setting to [HiSpeed]
Updated Intel MRC to v1.2
BIOS Firmware File